Browsing Category

Uncategorized

Three Things That Often Go Wrong in Water Heaters and How to Fix Them

Water heaters are the large, wide, cylindrical, metal tanks that often accompany washers and dryers in utility rooms. As you might infer from their name, water heaters are responsible for heating the water people use in their homes to shower, wash their hands, clean dishes, and more. Since water heaters are so important to modern living, it’s important to know how to fix them. Here are three likely fixes for three common water heater issues.

Rust-Colored, Red, or Brown Water

Rust, also known as oxidation, is what results naturally when iron, oxygen, and water come into contact with one another. Although the inside of water heaters are closed off from the world and usually filled to the brim with water, meaning there’s not much room for oxygen, they can and do still rust. Sacrificial anode rods are components of all water heaters that are made out of a mixture of metals that keep their interiors from rusting. If your hot water is rust-colored, red, or brown, you probably need a new anode rod. Replacing anode rods is difficult, meaning you might need a water heater repair service in the Seattle area to help you replace them.

Water Smells Bad

Sometimes, bacteria build up in water heaters, unleashing a foul smell whenever hot water handles are flipped open. If this has happened in your home, the easiest and most effective way to kill off this bacteria is to turn the tank’s temperature up to 140 degrees Fahrenheit. Let it sit for at least a day after the temperature is reached. Drain the tank and you should be good to go.

Long Reheat Times

Instead of looking for water heater repair services in Seattle if your water heater takes a long time to reheat, consider purchasing new heating elements. You can install them yourself, just make sure to drain the tank and turn off your home’s breakers first.

Installing a Well Jet Pump in La Vergne, TN – What You Need to Know

Modern wells operate in a very different manner as compared to the older ones that most people know about. The conventional well is basically a deep hole that is dug under the ground until the water table is reached. Wells have been dug for thousands of years and were used as the ideal source of extracting freshwater. In the past, the water could only be extracted with the help of a bucket. However, the process was inefficient. Thanks to the wonders of modern technology, a jet pump can be used. If you want to install a well jet pump in La Vergne, TN, you can get in touch with a local plumbing company in your area. Here are a few things that you should know about installing a well jet pump.

Types of Pumps

Well jet pumps are available in various sizes, and the specifications vary depending on your requirements. Some pumps are bigger than others and are capable of displacing more water. However, they also use greater amounts of electricity and are more difficult to maintain. Others, on the other hand, are slightly less expensive, but they are not as powerful. You should contact Holt Plumbing Company LLC if you want to install a new pump in your house.

Installation

The company will first need to visit your house to inspect the location of the well and then determine whether the well pump can be installed or not. The well jet pump will have to be fixed in a suitable location, and the pipes will be connected to the tank located above the ground from the well, so a strategic plan will need to be made first.